Vag com release 409.1 s1/15/2024 ![]() ![]() Im out of ideas other than maybe although i thought i needed the VAG-K+CAN cable for my cable maybe i needed the older KKL 409. engine, instrument etc etc it always comes up with "interface not found" When i try and connect to all the different interfaces i.e. Clicked on options, port3 and interface was found no problem with a good latency of between 1 and 2ms. Fired up XP, installed drivers and 409.1. Researching, i have seen a post from someone else saying same problem and they were recommended to try VAGCOM 409.1 in windows XP which they said worked great. I have tried VCDS Lite and in options chose port3 and interface is found but I then click on the different interfaces to connect to and none of them will connect, says "interface no found". ![]() All drivers in ok and interface found and i can get the system to run the car identification so seems all working fine but i just cant do anything with it, it doesnt read anything else from the drop down menu, ive tried them all. It came with vag commander 1.4 chinese edition. VAG-COM software Release 607.0 from Ross. ![]() Ive done a bit of research and purchased a VAG-K+CAN full commander cable which i believed the right cable for my car. Background VAG-COM (is an on-board diagnostic (OBD) scanner for Volkswagen Audi. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |